Digital SF200 Installation Guide download pdf (Page 91)

100

101

Installing a DECarray Cabinet

4.5 Installing the DECarray Cabinet in a Stripeset Conﬁguration

• Repeat this process for every KFMSA in the card cage, sequencing

through the DSSI ports on the DECarray I/O panel. Connect the

KFMSA DSSI bus 0 to odd numbered ports on the DECarray I/O

panel, and DSSI bus 1 to even numbered ports.

• Connect each TF8xx series magazine tape ISE to a separate DSSI

bus.

4.5.2 Labeling the Cables

This section describes how to correctly label the cables for the system, the

DECarray, and its storage enclosures and magazine tape ISEs.

At this point, all steps in the previous sections must be complete.

Digital Services or trained installers must perform the steps that follow.

4.5.2.1 Completing the System Conﬁguration Sheet

Fill out the system conﬁguration sheet. Blank conﬁguration worksheets are

provided in Appendix E and in the KFMSA Module Installation and User

Manual.

Note

Do not attempt to ﬁll out and place the labels until you have completed

the system conﬁguration sheet.

The information from the system conﬁguration sheet is used to ﬁll out the

labels correctly for all DSSI cables, SF7x OCPs, and magazine tape ISEs.

Refer to the inside cover of the SF Family Label Booklet for instructions on

ﬁlling out these labels.

Installing a DECarray Cabinet 4–41

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 379 380

Comments to this Manuals

No comments

Digital SF200 Installation Guide Page 91

Comments to this Manuals

Related products and manuals for Electrical enclosures Digital SF200