Digital SF200 Installation Guide download pdf (Page 152)

100

101

Installing the SF7x Storage Enclosure in a DECarray Cabinet

6.5 Installation Procedure

This section describes the step-by-step procedures for installing an SF7x

storage enclosure in DECarray positions 1, 2, 3, 4, 7, or 8.

Be sure to do the following:

• Follow each step in order, and do not skip any steps

• Leave sufﬁcient room to perform the installation (approximately 1.5 meters

to 1.8 meters [5 feet to 6 feet] front and rear of the DECarray)

WARNING

Observe all ESD precautions and procedures. An antistatic wrist strap

is provided inside the DECarray front and rear doors.

WARNING

Do not attempt to pick up or support the SF7x by the handle in the

rear of the enclosure. Doing so will injure the person attempting the

installation or damage the power supply.

To maintain stability, extend only one SF7x storage enclosure or

magazine tape ISE on the slide mounts at a time.

6.5.1 Preparing the DECarray Cabinet

The following procedure describes how to prepare the DECarray cabinet to

receive the SF7x storage enclosure(s):

1. Place the SF7x to be installed to one side, in front of the DECarray cabinet.

2. Open the front and rear doors of the DECarray (Figure 6–3).

3. Remove the front door ﬁller panel that corresponds to the position of the

DECarray you are installing (Figure 6–3).

6–10 Installing the SF7x Storage Enclosure in a DECarray Cabinet

1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 379 380

Comments to this Manuals

No comments

Digital SF200 Installation Guide Page 152

Comments to this Manuals

Related products and manuals for Electrical enclosures Digital SF200