Installing the Magazine Tape ISE in a DECarray Cabinet
8.1 Installing the TF8x7 Storage Enclosure
i. While facing the front of the cabinet, install two 7/16-inch shoulder
screws with washers (hand-tighten)—one screw in the bottom threaded
hole and the other in the threaded hole beneath the center rear
shoulder screw (hand-tighten) previously installed.
j. Tighten all shoulder screws.
k. Tighten the four slide mount screws.
Figure 8–5 Installing the Slide Mount
LOCKWASHER (5)
90-06637-00
7/16-INCH SHOULDER SCREW (3)
12-24007-02
DSSI CABLE RETAINER
74-41302-01
LOCKWASHER (3)
90-06637-00
SHR-X0129A-90
SLIDE MOUNT
NOTE TO ILLUSTRATOR:
This is reduced at 18%
of original
7/16-INCH
SHOULDER
SCREW (3)
12-24007-02
1/2-INCH
SHOULDER
SCREW (2)
12-24007-01
l. From the front of the cabinet, install the upper and lower weldment
brackets on the cabinet side rail using 1/2-inch shoulder screws and
washers (Figure 8–6).
The center hole of the weldment bracket goes over the guide pin on the
slide mount so the large end of the top weldment bracket points up and
the large end of the bottom weldment bracket points down, regardless
of whether you are installing the brackets on the front right or left
cabinet frame rails.
Installing the Magazine Tape ISE in a DECarray Cabinet 8–15
Comments to this Manuals