Digital SF200 Installation Guide download pdf (Page 261)

100

101

Installation Troubleshooting

9.2 Removing an RF Disk ISE from an SF3x Storage Enclosure

9.2 Removing an RF Disk ISE from an SF3x Storage

Enclosure

This section describes the procedure for removing a disk ISE from an SF3x

storage enclosure.

WARNING

Take all possible ESD precautions when unpacking the disk ISEs.

Wear a correctly grounded ESD strap.

Perform an orderly shutdown of the SF3x enclosure containing the disk

ISE. Refer to the system documentation.

1. Power down the SF3x enclosure.

a. Take the failed disk ISE on that DSSI bus off-line by pressing and

releasing each Ready button on the operator control panel (OCP). The

button indicators go out.

b. Press and release the drive dc power switches for all the ISEs on that

DSSI bus.

2. Remove the disk ISE from the SF3x enclosure (Figure 9–1).

a. Remove the cover.

b. Remove the screw from the ISE carrier lever.

c. Pull the lever forward and slide the carrier out of the slot.

Installation Troubleshooting 9–7

1 2 ... 256 257 258 259 260 261 262 263 264 265 266 ... 379 380

Comments to this Manuals

No comments

Digital SF200 Installation Guide Page 261

Comments to this Manuals

Related products and manuals for Electrical enclosures Digital SF200