Digital SF200 Installation Guide Page 225
- Page / 313
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
- SF200 Storage Array 1
- Installation Guide 1
- Contents 3
- Storage Array 4
- Configuration 6
- Contents ix 9
- Contents xi 11
- About This Guide 12
- Introduction 13
- 1–2 Introduction 14
- Introduction 1–5 17
- 1–6 Introduction 18
- 1.3 Related Documentation 20
- CXO-2468A 24
- SHR_X1114_89 24
- 3.1 Unpacking 26
- SHIPPING 28
- CXO-688C_S 29
- SHR_X1103_89_SCN 29
- CXO-924A_S 31
- SHR_X1104_89_SCN 31
- 3.3 Placing the Array 32
- SHR-X0123-90 33
- 3.4 Leveling the Array 34
- SHR_X1127A_89 35
- 120 Vac, 60 Hz 36
- 240 Vac, 50 Hz 36
- Selection 38
- VAX 6000 Series System 40
- 4.1 Single-Host Overview 41
- 4.2 Dual-Host Overview 43
- SHR-X0107-90 50
- System I/O Panel 56
- Figure 4–12 65
- DSSI TERMINATOR 80
- SHR-X0121-90 80
- LABEL AREA 80
- Figure 4–26 88
- 5.1 Steps to Install 94
- Table 5–2 SF72 Kit Contents 96
- 5.1.4 Installation Procedure 102
- SHR_X1108A_89 103
- SF72 FILLER PANEL 103
- TF FILLER PANEL 103
- SHR-X0137-90 105
- SHR-X0130A-90 107
- SHR-X0131A-90 109
- This illustration 109
- SEMS SCREWS (4) 110
- 12-21368-03 110
- RETAINERS 110
- SHR-X0132A-90 112
- SHR_X1111_89 114
- SHR-X0124-90 115
- SHR_X1128B_89 117
- SHR_X1113_89_SCN 119
- SHR-X0126A-90 120
- SHR-X0127A-90 122
- SHR-X0122-90 133
- 5.2.2 Dual-Host Configuration 143
- 5.3 Powering Up the SF72 164
- 5.4.1 Filling Out the Labels 165
- 5.4.2 Labeling the Cables 166
- 5.4.3 Labeling the OCP 167
- 5.5 Final Verification 168
- 6.1 Steps to Install 171
- SHR_X1101_89 175
- 6.1.4 Installion Procedure 179
- SHR-X0129A-90 186
- CONNECTORS 193
- AC RECEPTACLE 193
- AC POWER 193
- Position 194
- 6.2.2 Dual-Host Configuration 203
- Subsystem 210
- SHR-X0108-90 211
- MODE SELECT KEY SWITCH 213
- OPERATOR CONTROL PANEL 213
- 6.5 Final Verification 214
- Installation Troubleshooting 215
- Enclosure 220
- 2. Remove the RF72 disk ISE 222
- SHR-X0135A-90 223
- SHR-X0135-90 224
- SHR-X0136A-90 224
- SKID PLATE 225
- Proceed to Section 7.1.2 228
- (Section A.2) configurations 230
- Table A–1 Cabling Diagram Key 230
- A.1 Single-Host Configuration 232
- A.2 Dual-Host Configuration 253
- MKV−R105−91 259
- MKV−R101−91 268
- Subsystems Only) 272
- Upgrade Kit 274
- Storage Enclosure 277
- B.4 Powering Up the ISEs 283
- C.2 Conversion Procedure 289
- SHR_X1110_89 291
- C.2.3 Labeling the Cables 298
- SHR_X1128C_89 302
- SHR_X1128_89 304
- C.2.6 Final Verification 306
- Glossary 307
Related products and manuals for Electrical enclosures Digital SF200
(43 pages)© 2020, manymanuals.com. All rights reserved. | 0.324 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals