Digital SF200 Specifications download pdf (Page 8)

Close the magazine cover. You are now ready to begin scanning. For details on automatic consecutive

scanning of multiple slides, refer to the software reference manual.

Slides can be loaded into the feed magazine up to the load mark. Do not attempt to fill the magazine

past this point. Once the feed magazine is loaded, release the push plate from the notch and slide it

back until rests against the slides.

4. Using the SF-200 (S)

This chapter describes how to load the SF-200 (S), how to remove slides, and how to deal with jams.

4.1 Loading the feeder

Slides to be scanned are inserted in the feed magazine. To load the magazine, open the magazine cover,

pull back the feed push-plate to the end of its grove, and hook it in the notch so that it does not spring

back to its original position. Place the slides in the magazine with the long end of the aperture up and

the emulsion surface facing the push plate (the images in the slides should be reversed when viewed

from the magazine side). Scanning will be considerably simplified if the slides are all inserted in the same

orientation.

Load mark

Notch

Magazine cover

Push plate

Ejection magazine

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Digital SF200 Specifications Page 8