Introduction
The E-Series satellite controller with OSMAC Digital Wireless Paging is designed for installation on a substantial con-
crete foundation with imbedded conduit of various diameters to enable power, field and earth ground wiring to be routed
into the cabinet. A mounting bolt positioner and basic mounting hardware components are included with each controller.
Additional materials required to complete the installation must be obtained separately. A material list can be compiled by
reading through the instructions completely prior to starting the installation.
CAUTION: For your protection and the safety of the product user, comply with all Caution and Warning
statements within this document. All installation practices must comply with all applicable national and/or
local electrical and construction codes.
Foundation Construction
1. Prepare a hole for the foundation and
wiring conduit using the minimum recom-
mended dimensions shown in Figure 1.
*Note: Refer to local electrical codes for
required depth of buried wiring.
2. Trench to the foundation site as required
for each wiring run.
3. Position straight and sweep elbow con-
duit sections in foundation hole as
shown. Tape the conduit ends to seal out
dirt. Backfill soil to form a 6" (15.2cm)
foundation depth. Conduit should not
extend more than 2" above the finished
top surface of the foundation.
4. Prepare the sides of the foundation hole
with wood forms.
5. Prepare the mounting bolt positioner
with the 5/16 x 4-1/2" bolts and nuts
(provided) as shown in Figure 1. The
threads should extend 2" (51mm) from
the top surface of the bolt positioner.
6. Pour concrete into the formed founda-
tion hole. Press the mounting bolt posi-
tioner into the concrete until it is flush
and level with the foundation surface
and aligned with the conduit.
7. Finish the concrete with a level flat area
for the pedestal base (13" x 13"
[33cm x 33cm] for the metal cabinet or
16" x 16" [41cm x 41cm] for the plastic
cabinet). To prevent pooling at the base
of the pedestal, add a slight taper away
from the cabinet base contact area.
Allow concrete to sufficiently harden
before continuing.
8. Remove the hex nuts from the mounting
bolts. Place the pedestal on the pad
ensuring all bolts pass though the holes
provided. Install a flat washer and a hex
nut on each bolt and tighten securely.
E-Series Satellite Controller
OSMAC Digital Wireless Paging System (Narrow Band)
Installation and Operating Instructions
6" (15.2cm)
2" (51mm) Max.
2"
(51mm)
Wood Form
Mounting Bolt
Positioner
Concrete
Mounting Bolt Positioner
See *Note
Plastic Cabinet Base Area
Metal Cabinet Base Area
Taper
30"
(76cm)
30"
(76cm)
FRONT
Figure 1
3" (76mm) Conduit – Field
(32 Stations Each)
3/4" (19mm) Conduit–
AC Power
Mounting Bolt w/ Hex Nuts
(Typical 4 Places)
3/4" (19mm) Conduit –
Earth Ground
Comments to this Manuals